Service Manual

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information This command enables the SSH server and begins listening on a port. If a port is not
specified, listening is on SSH default port 22.
NOTE: Starting with Dell Networking OS Release 9.2(0.0), SSH server is enabled
by default.
Example
Dell# conf
Dell(conf)# ip ssh server port 45
Dell(conf)# ip ssh server enable
Dell#
ip ssh server vrf
Configure an SSH server on either a specific VRF or a management VRF.
Syntax
NOTE: Some of the parameters in this command require licensing to access. For
more information, contact your Dell Networking representative.
ip ssh server vrf {management | vrf-name}
To disable the SSH server configuration, use the no ip ssh server vrf
{management | vrf-name} command.
Parameters
vrf management Enter the keyword vrf followed by the keyword management to
configure an SSH server on a management VRF.
vrf vrf-name Enter the keyword vrf followed by the VRF name to configure
an SSH server on that VRF.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
Security 1777