Service Manual

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a Null interface, enter the keyword null then the Null
interface number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command Modes TACACS SERVER GROUP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage Information
You can use this command to associate a group of TACACS servers with a VRF and
source interface. You can configure the source interface only with the VRF attribute
and source interface is optional with the VRF attributes.
If VRF is not configured on the TACACS group, then the group is considered to be on
the default VRF.
RADIUS groups and VRFs have one-to-one mapping. If a VRF is configured with one
RADIUS group, then you cannot use the same VRF with another RADIUS group. When
the VRF is removed, then the corresponding RADIUS group is also removed
automatically.
Example
Dell(conf)# tacacs-server group group1
Dell(conf-tacacs-group)# tacacs-server vrf vrf1 source-interface
tengigabitethernet 1/36
Dell(conf)# tacacs-server group group2
Dell(conf-tacacs-group)# tacacs-server vrf default
Security 1744