Service Manual

Parameters
update Enter the number of seconds to specify the rate at which RIP
routing updates are sent. The range is from zero (0) to
4294967295. The default is 30 seconds.
invalid Enter the number of seconds to specify the time interval before
routing updates are declared invalid or expired. The invalid value
should be at least three times the update timer value. The range
is from zero (0) to 4294967295. The default is 180 seconds.
holddown Enter the number of seconds to specify a time interval during
which the route is marked as unreachable but still sending RIP
packets. The holddown value should be at least three times the
update timer value. The range is from zero (0) to 4294967295.
The default is 180 seconds.
flush Enter the number of seconds to specify the time interval during
which the route is advertised as unreachable. When this interval
expires, the route is flushed from the routing table. The flush
value should be greater than the update value. The range is from
zero (0) to 4294967295. The default is 240 seconds.
Defaults
• update = 30 seconds
• invalid = 180 seconds
• holddown = 180 seconds
• flush = 240 seconds
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
Routing Information Protocol (RIP) 1652