Service Manual

show ip rip database
Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
S4048–ON
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address (OPTIONAL) Specify an IP address in dotted decimal format to
view RIP information on that network only. If you enter an IP
address, also enter a mask for that IP address.
mask (OPTIONAL) Specify a mask, in /network format, for the IP
address.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information The following describes the show ip rip database command shown in the
following example.
Routing Information Protocol (RIP) 1649