Service Manual

Table Of Contents

router rip

To configure and enable RIP, enter ROUTER RIP mode.

S4048–ON

Syntax

router rip

To disable RIP, use the no router rip command.

Defaults Disabled.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.6.1.0 Introduced on the C-Series.

pre- 6.2.1.1 Introduced on the E-Series.

Usage Information To enable RIP, assign a network address using the network command.

Example

Dell(conf)# router rip

Dell(conf-router_rip)#

Commands

• network — enables RIP.

• exit — returns to CONFIGURATION mode.

Routing Information Protocol (RIP) 1647