Service Manual

Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 7.7.1.0 Introduced on the E-Series.
Related
Commands
• router rip — enters ROUTER mode on the switch.
distance
Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower weights
(“administrative distance”) are preferred.
S4048–ON
Syntax
distance weight [ip-address mask [prefix-name]]
To return to the default values, use the no distance weight [ip-address mask]
command.
Parameters
weight Enter a number from 1 to 255 for the weight (for prioritization).
The default is 120.
ip-address (OPTIONAL) Enter the IP address, in dotted decimal format
(A.B.C.D), of the host or network to receive the new distance
metric.
mask If you enter an IP address, also enter a mask for that IP address,
in either dotted decimal format or /prefix format (/x).
prefix-name (OPTIONAL) Enter a configured prefix list name.
Routing Information Protocol (RIP) 1628