Service Manual

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Policy name character limit increased from 16 to 32.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Expanded to add support for Layer 2.
6.1.1.1 Introduced on the E-Series.
Usage Information The input policy map is used to classify incoming traffic to different flows using class-
map, QoS policy, or incoming packets DSCP. This command enables Policy-Map-Input
Configuration mode (conf-policy-map-in). When you configure an input policy map for
CoPP, you must enter the keyword cpu-qos .
Related
Commands
• service-queue — assigns a class map and QoS policy to different queues.
• service-policy input — applies an input policy map to the selected interface.
policy-map-output
Create an output policy map.
S4048–ON
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-name Enter the name for the policy map in character format (32
characters maximum).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
Quality of Service (QoS) 1581