Service Manual

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Expanded the command to permit configuration on port
channels.
6.1.1.1 Introduced on the E-Series.
Usage Information
To honor all incoming 802.1p markings on incoming switched traffic on the interface,
enter this command. By default, this facility is not enabled (that is, the 802.1p markings
on incoming traffic are not honored).
You can apply this command on both physical interfaces and port channels. When you
set the service-class dynamic for a port channel, the physical interfaces assigned to the
port channel are automatically configured; you cannot assign the service-class
dynamic
command to individual interfaces in a port channel.
• All dot1p traffic is mapped to Queue 0 unless you enable the service-class
dynamic dot1p command on an interface or globally.
• Layer 2 or Layer 3 service policies supersede dot1p service classes.
strict-priority queue
Configure a unicast queue as a strict-priority (SP) queue.
S4048–ON
Syntax
strict-priority queue unicast number
Parameters
unicast number Enter the keyword unicast then the queue number. The range
is from 1 to 3.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Quality of Service (QoS) 1563