Service Manual

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
7.7.1.1 Introduced
Usage Information This command configures an expiration timer for all S.G entries, unless they are
assigned to an Extended ACL.
Even though the FHR nodes act as RPs, these nodes still send Register encap messages
to themselves and expect to receive a Register stop message (for Anycast RP support).
As a result, if the DLT timer expires, SG is not deleted until the register state is deleted in
the node. This register state expires 210 seconds after the last Null register is received.
ip pim ssm-range
Specify the SSM group range using an access list.
Syntax
ip pim [vrf vrf-name] ssm-range {access_list_name}
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to specify the SSM group range for that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
access_list_name Enter the name of the access list.
Defaults Default SSM range is 232/8 and ff3x/32
Command Modes CONFIGURATION
PIM-Sparse Mode (PIM-SM) 1499