Service Manual

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
Usage Information The interface must be enabled (the no shutdown command) and not have the
switchport command configured. Multicast must also be enabled globally (using the
ip multicast-lag-hashing command). PIM is supported on the port-channel
interface.
ip pim sparse-mode sg-expiry-timer
Enable expiry timers globally for all sources.
Syntax
ip pim [vrf vrf-name] sparse-mode sg-expiry-timer seconds [access-
list-name]
To disable configured timers and return to default mode, use the no ip pim [vrf
vrf-name] sparse-mode sg-expiry-timer command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to enable expiry timer for all sources on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
seconds Enter the number of seconds the S, G entries are retained. The
range is from 211 to 65535.
access-list-name (OPTIONAL) Enter the name of a previously configured
Extended ACL to enable the expiry time to specified S,G entries.
Defaults Disabled. The default expiry timer (with no times configured) is 210 sec.
Command Modes CONFIGURATION
PIM-Sparse Mode (PIM-SM) 1498