Service Manual

Dell(config-if-te-1/1)# ip pim ingress-interface-map map1
Dell(config-if-te-1/1)#
ip pim neighbor-filter
To prevent a router from participating in protocol independent multicast (PIM), configure this feature.
Syntax
ip pim [vrf vrf-name] neighbor-filter {access-list}
To remove the restriction, use the no ip pim [vrf vrf-name] neighbor-filter
{access-list} command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to prevent that VRF from participating in PIM.
NOTE: Applies to specific VRF if input is provided, else
applies to default VRF.
access-list Enter the name of a standard access list. Maximum 16
characters.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced on the E-Series.
PIM-Sparse Mode (PIM-SM) 1492