Service Manual

ip pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command
prevents the PIM-SM router from creating state based on multicast source and/or group.
Syntax
ip pim [vrf vrf-name] join-filter ext-access-list [in | out]
To remove the access list, use the no ip pim [vrf vrf-name] join-filter
ext-access-list command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to permit or deny PIM join or prune messages on an
interface associated with that VRF.
ext-access-list Enter the name of an extended access list.
in Enter the keyword in to apply the ACL filter to in-bound traffic.
out Enterthe keyword out to apply the ACL filter to out-bound
traffic.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Removed the in and out parameters. Introduced on the S6000-
ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
PIM-Sparse Mode (PIM-SM) 1490