Service Manual

To disable OSPFv6 routing for an interface, use the no ipv6 ospf process-id
area area-id command.
Parameters
process-id Enter the process identification number.
area area-id Specify the OSPF area. The range is from 0 to 65535.
Defaults None
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.4.1.0 Introduced on the E-Series and C-Series.
ipv6 ospf authentication
Configure an IPsec authentication policy for OSPFv3 packets on an IPv6 interface.
Syntax
ipv6 ospf authentication {null | ipsec spi number {MD5 | SHA1}
[key-encryption-type] key}}
Parameters
null Causes an authentication policy configured for the area to not
be inherited on the interface.
ipsec spi number Security Policy index (SPI) value that identifies an IPsec security
policy. The range is from 256 to 4294967295.
MD5 | SHA1
Authentication type: Message Digest 5 (MD5) or Secure Hash
Algorithm 1 (SHA-1).
key-encryption-
type
(OPTIONAL) Specifies if the key is encrypted.
Open Shortest Path First (OSPFv2 and OSPFv3) 1444