Service Manual

unplanned-only (OPTIONAL) Enter the keywords unplanned-only to indicate
graceful restart is supported in an unplanned restart condition
only.
Defaults OSPFv3 graceful restart supports both planned and unplanned failures.
Command Modes ROUTER OSPFv3
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.4.2.2 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage Information
OSPFv3 graceful restart supports planned-only and/or unplanned-only restarts. The
default is support for both planned and unplanned restarts.
• A planned restart occurs when you enter the redundancy force-failover
rpm command to force the primary RPM to switch to the backup RPM. During a
planned restart, OSPF sends out a Type-11 Grace LSA before the system switches
over to the backup RPM.
• An unplanned restart occurs when an unplanned event causes the active RPM to
switch to the backup RPM, such as when an active process crashes, the active
RPM is removed, or a power failure happens. During an unplanned restart, OSPF
sends out a Grace LSA when the backup RPM comes online.
By default, both planned and unplanned restarts trigger an OSPFv3 graceful restart.
Selecting one or the other mode restricts OSPFv3 to the single selected mode.
ipv6 ospf area
Enable IPv6 OSPF on an interface.
Syntax
ipv6 ospf process id areaarea id
Open Shortest Path First (OSPFv2 and OSPFv3) 1443