Service Manual

key-encryption-
type
(OPTIONAL) Specifies if the key is encrypted.
The values are 0 (key is not encrypted) or 7 (key is encrypted).
key
Text string used in authentication.
For MD5 authentication, the key must be 32 hex digits (non-
encrypted) or 64 hex digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits (non-
encrypted) or 80 hex digits (encrypted).
Defaults Not configured.
Command Modes ROUTER OSPFv3
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
8.4.2.0 Introduced on the E-Series.
Usage Information Before you enable IPsec authentication on an OSPFv3 area, you must first enable
OSPFv3 globally on the router. Configure the same authentication policy (same SPI and
key) on each interface in an OSPFv3 link.
An SPI number must be unique to one IPsec security policy (authentication or
encryption) on the router.
If you have enabled IPsec encryption in an OSPFv3 area with the area encryption
command, you cannot use the area authentication command in the area at the
same time.
The configuration of IPsec authentication on an interface-level takes precedence over
an area-level configuration. If you remove an interface configuration, an area
authentication policy that has been configured is applied to the interface.
To remove an IPsec authentication policy from an OSPFv3 area, enter the no area
area-id authentication spi
number command.
Open Shortest Path First (OSPFv2 and OSPFv3) 1432