Service Manual

Usage Information Setting the delay and holdtime parameters to a low number enables the switch to an
alternate path quickly but requires more CPU usage.
Example
Dell# conf
Dell(conf)# router ospf 1
Dell(conf-router_ospf-1)# timer spf 2 5
Dell(conf-router_ospf-1)# show config
!
router ospf 1
timers spf 2 5
Dell(conf-router_ospf-1)# end
timers throttle lsa all
Configure LSA transmit intervals.
Syntax
timers throttle lsa all {start-interval | hold-interval | max-
interval}
To return to the default, use the no timers throttle lsa command.
Parameters
start-interval Set the minimum interval between initial sending and resending
the same LSA. The range is from 0 to 600,000 milliseconds.
hold-interval Set the next interval to send the same LSA. This interval is the
time between sending the same LSA after the start-interval has
been attempted. The range is from 1 to 600,000 milliseconds.
max-interval Set the maximum amount of time the system waits before
sending the LSA. The range is from 1 to 600,000 milliseconds.
Defaults
• start-interval: 0 msec
• hold-interval: 5000 msec
• max-interval: 5000 msec
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Open Shortest Path First (OSPFv2 and OSPFv3) 1429