Service Manual

• The previous no passive-interface interface is removed from the running
configuration.
• The ABR status for the router is updated.
• Save passive-interface interface into the running configuration.
passive-interface default
• All present and future OSPF interfaces are marked as passive.
• Any adjacency is explicitly terminated from all OSPF interfaces.
• All previous passive-interface interface commands are removed from the
running configuration.
• All previous no passive-interface interface commands are removed from
the running configuration.
no passive-interface interface
• Remove the interface from the passive list.
• The ABR status for the router is updated.
• If passive-interface default is specified, then save no passive-
interface interface into the running configuration.
No passive-interface default
• Clear everything and revert to the default behavior.
• All previously marked passive interfaces are removed.
• May update ABR status.
On configuring suppression using the passive-interface command, the state of the
OSPF neighbor does not change to INIT; instead, the state of the OSPF neighbor
changes to DOWN after the dead-timer expires.
redistribute
Redistribute information from another routing protocol throughout the OSPF process.
S4048–ON
Syntax
redistribute {connected | isis | ospf | rip | static} [metric
metric-value | metric-type type-value] [route-map map-name] [tag
tag-value]
To disable redistribution, use the no redistribute {connected | isis | rip |
static} command.
Parameters
connected Enter the keyword connected to specify that information from
active routes on interfaces is redistributed.
Open Shortest Path First (OSPFv2 and OSPFv3) 1383