Service Manual

threshold is 255. The notification of a change in the state of a tracked object is sent
when a metric value crosses a configured threshold.
Related
Commands
• show track – display information about tracked objects, including configuration,
current state, and clients which track the object.
• threshold metric – configure the metric threshold used to determine the UP
and/or DOWN state of a tracked route.
• track resolution ip route – configure the protocol-specific resolution value used
to scale an IPv4 route metric.
track ip route reachability
Configure object tracking on the reachability of an IPv4 route.
Syntax
track object-id ip route ip-address/prefix-len reachability [vrf
vrf-name]
To return to the default setting, use the no track object-id command.
Parameters
object-id Enter the ID number of the tracked object. The range is 1 to 500.
ip-address/
prefix-len
Enter an IPv4 address in dotted decimal format. The valid IPv4
prefix lengths are from /0 to /32.
vrf vrf-name (Optional) E-Series only: You can configure a VPN routing and
forwarding (VRF) instance to specify the virtual routing table to
which the tracked route belongs.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Object Tracking 1332