Service Manual

retrans-timer 101
router-preference maximum medium
trusted-port
Dell(conf-ra_guard_policy_list)#
Related
Commands
• ipv6 nd ra-guard enable — configure the RA guard related commands.
• ipv6 nd ra-guard policy — define the RA guard policy name and enter the RA
guard policy list configuration mode.
• device-role — specify the role of the device attached to the port.
• hop-limit — enable the verification of the advertised hop count limit.
• mtu — set the maximum transmission unit (MTU) value.
• other-config-flag — enable the verification of the advertised other configuration
parameter.
• reachable-time — set the advertised reachability time.
• retrans-timer — set the advertised retransmission time.
• router-preference maximum — enable the verification of the advertised default
router preference (DRP) value.
• trusted-port — apply the policy to trusted ports.
show ipv6 nd ra-guard policy
Display the configurations applied on all the RA guard policies or a specific RA guard policy.
Syntax
show ipv6 nd ra-guard policy policy-name
Parameter
policy policy-
name
Enter the keyword policy then the policy name. The policy
name allows a maximum of 140 characters.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.9(0.0) Introduced on the Z9500.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, Introduced on
the S6000–ON, and Z9000 switches.
Example
Dell# show ipv6 nd ra-guard policy test
Neighbor Discovery Protocol (NDP) 1316