Service Manual

show ipv6 neighbors
Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor addresses
stored on the control processor (CP).
Syntax
show ipv6 neighbors [vrf vrf-name] [ipv6-address| interface
interface]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and the name of the VRF to
display the neighbors corresponding to that VRF.
NOTE: If you do not specify this option, neighbors
corresponding to the default VRF are displayed.
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
interface interface Enter the keyword interface then the interface type and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
• For a Port Channel interface, enter the keywords port-
channel followed by a number.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a VLAN interface, enter the keyword vlan then a number
from 1 to 4094.
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Neighbor Discovery Protocol (NDP) 1303