Service Manual

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
Usage Information Advertise the Extended Power via MDI on all ports that are connected to an 802.3af
powered, LLDP-MED endpoint device.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
advertise med softphone-voice
To advertise softphone to enable IP telephony on a computer so that the computer can be used as a phone,
configure the system.
Syntax
advertise med softphone-voice {vlan-id layer2_priority DSCP_value}
| {priority-tagged number}
To return to the default, use the no advertise med softphone-voice {vlan-id
layer2_priority DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority. The range is from 0 to 7.
DSCP_value Enter the DSCP value. The range is from 0 to 63.
priority-tagged
number
Enter the keywords priority-tagged, the Layer 2 priority, and
then the DSCP value.
Defaults Unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Link Layer Discovery Protocol (LLDP) 1239