Service Manual

enable xfp-power-updates
Enable 10–gigabit small form-factor pluggable (XFP) power updates for SNMP.
Syntax
enable xfp-power-updates interval seconds
Parameters
interval seconds Enter the keyword interval then the polling interval in
seconds. The range is from 120 to 6000 seconds. Default: 300
seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
8.3.19.0 Deprecated command for S4820T. Replaced by the enable
optic-info-update interval command to update
information on temperature and power monitoring in the SNMP
MIB.
8.3.11.4 Deprecated command for Z9000. Replaced by the enable
optic-info-update interval command to update
information on temperature and power monitoring in the SNMP
MIB.
8.3.10.0 Deprecated command for the S4810 only. Replaced by the
enable optic-info-update interval command to update
information on temperature and power monitoring in the SNMP
MIB.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
Usage Information The chassis MIB contains the entry chSysXfpRecvPower in the chSysPortTable
table. Periodically, IFA polls the XFP power for each of the ports and sends the values to
IFM where it is cached.
To enable polling and to configure the polling frequency, use this command.
Control and Monitoring 115