Service Manual

NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not
need to enter an enable password.
Related
Commands
• enable password — configures a password for the enable command and to
access a privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Syntax
enable optical-info-update [interval seconds]
To disable optical power information updates, use the no enable optical-info-
update interval command.
Parameters
interval seconds Enter the keyword interval then the polling interval in
seconds. The range is from 120 to 6000 seconds. The default is
300 seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Replacement command for the S4820T. Replaces the enable
xfp-power-updates command.
8.3.11.4 Replacement command for the Z9000. Replaces the enable
xfp-power-updates command
8.3.10.0 Replacement command for the S4810 only. Replaces the
enable xfp-power-updates command.
Usage Information To enable polling and to configure the polling frequency, use this command.
Control and Monitoring 114