Service Manual

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.5.1.0 Added support for LSP Throttling Enhancement.
Usage Information To configure the number of area addresses on router, use this command. This value
must be consistent with routers in the same area, otherwise the router forms only Level
2 adjacencies. The value must be same among all the routers to form Level 1
adjacencies.
max-lsp-lifetime
Set the maximum time that link-state packets (LSPs) exist without being refreshed.
Syntax
max-lsp-lifetime seconds
To restore the default time, use the no max-lsp-lifetime command.
Parameters
seconds The maximum lifetime of LSP in seconds. This value must be
greater than the lsp-refresh-interval command. The
higher the value the longer the LSPs are kept. The range is from
1 to 65535. The default is 1200.
Defaults 1200 seconds
Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Intermediate System to Intermediate System (IS-IS) 1134