Service Manual

lsp-gen-interval
Set the minimum interval between successive generations of link-state packets (LSPs).
Syntax
lsp-gen-interval [level-l | level-2] interval seconds
[initial_wait_interval seconds [second_wait_interval seconds]]
To restore default values, use the no lsp-gen-interval [level-l | level-2]
interval seconds [initial_wait_interval seconds
[second_wait_interval seconds]] command.
Parameters
level-l (OPTIONAL) Enter the keywords level-1 to apply the
configuration to generation of Level-1 LSPs.
level-2 (OPTIONAL) Enter the keywords level-2 to apply the
configuration to generation of Level-2 LSPs.
interval seconds Enter the maximum number of seconds between LSP
generations. The range is from 0 to 120 seconds. The default is 5
seconds.
initial_wait_interv
al seconds
(OPTIONAL) Enter the initial wait time, in seconds, before
running the first LSP generation. The range is from 0 to 120
seconds. The default is 1 second.
second_wait_inte
rval seconds
(OPTIONAL) Enter the wait interval, in seconds, between the first
and second LSP generation. The range is from 0 to 120 seconds.
The default is 5 seconds.
Defaults See Parameters.
Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Intermediate System to Intermediate System (IS-IS) 1130