Service Manual

and other paths do not have any weight configured, then regular ECMP is used for
forwarding.
You can specify the weight value only to destination address and not on the egress
port.
A route is considered for weighted ECMP calculations only if each paths corresponding
to that route is configured with a weight.
Example
Dell(conf)# ipv6 route 44::/64 33::1 weight 100
Dell(conf)# ipv6 route 44::/64 33::2 weight 200
Dell(conf)# do show running-config | grep ipv6 route
Dell(conf)# ipv6 route vrf vrf_test 44::/64 33::1 weight 100
Dell(conf)# ipv6 route vrf vrf_test 44::/64 33::2 weight 200
Dell(conf)# do show running-config | grep ipv6 route vrf
Related
Commands
• show ipv6 route — view the IPv6 configured routes.
ipv6 unicast-routing
Enable IPv6 unicast routing on the device.
Syntax
ipv6 unicast-routing
To disable unicast routing, use the no ipv6 unicast-routing command.
Defaults Enabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
IPv6 Basics 1060