Service Manual

Example
Dell(conf)# int ten 1/4
Dell(conf-if-te-1/4)# ipv6 address 200:1::/64 eui64
Dell(conf)# int ten 1/6
Dell(conf-if-te-1/6)# ipv6 address 801:10::/64 eui64
ipv6 control-plane icmp error-rate-
limit
Configure the maximum number of ICMP error packets per second that can be sent per second.
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-rate-
limit command.
Parameters
pps Enter the maximum number of error packets generated per
second. The range is from 1 to 200, where 0 disables the rate-
limiting.
Default 100 pps
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
IPv6 Basics 1051