Service Manual

To delete an access list, use the no ipv6 access-list access-list-name
command.
Parameters
access-list-name Enter the access list name as a string, up to 140 characters.
cpu-qos Enter the keyword cpu-qos to assign this ACL to control plane
traffic only (CoPP).
permit Enter the keyword permit to configure a filter to forward
packets meeting this condition.
deny Enter the keyword deny to configure a filter to drop packets
meeting this condition.
ospfv3 Specify that this ACL is for OSPFv3 control plane traffic
Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packet is
dropped.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for CoPP for OSPFv3 on the S4810, S4820T,
S6000, and Z9000 platforms.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000
8.3.11.1 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series. Increased the name string to accept
up to 140 characters. Prior to version 7.8.1.0, names are up to 16
characters long.
7.4.1.0 Introduced on the E-Series.
Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed
specification on entries allowed per ACL, refer to your line card documentation. You
IPv6 Access Control Lists (IPv6 ACLs) 1039