Service Manual

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip route summary shown in the following
example.
Column
Heading
Description
Route Source Identifies how the route is configured in Dell Networking OS.
Active Routes Identifies the best route if a route is learned from two protocol
sources.
Non-active
Routes
Identifies the back-up routes when a route is learned by two
different protocols. If the best route or active route goes down,
the non-active route becomes the best route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are
advertised, then information on those routes is displayed.
Total 1388
active...
Displays the number of active and non-active routes and the
memory usage of those routes. If there are no routes configured
in the Dell Networking OS, this line does not appear.
Example
Dell> show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
IPv4 Routing 1025