Service Manual

Version Description
pre-6.1.1.0 Introduced on the E-Series.
Example
Dell# show ip management-route
Destination Gateway State
----------- ------- -----
10.1.2.0/24 ManagementEthernet 1/1 Connected
172.16.1.0/24 10.1.2.4 Active
Dell#
show ipv6 management-route
Display the IPv6 static routes configured for the management interface.
Syntax
show ipv6 management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses
assigned to all Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes
directly connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing
the number of active and non-active routes and their sources.
static (OPTIONAL) Enter the keyword static to view non-active
routes also.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
IPv4 Routing 1016