Service Manual

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage Information
When this command is congured, the VLAN is operationally UP if any of the interfaces specied in the track
ip command are operationally UP, and the VLAN is operationally DOWN if none of the tracking interfaces are
operationally UP.
If the track ip command is not congured, the VLAN's Layer 3 operational state depends on all the members of
the VLAN.
The Layer 2 state of the VLAN, and the Layer 2 trac, is not aected by the track ip command conguration.
Related Commands
• interface vlan — congure a VLAN.
• tagged — specify which interfaces in a VLAN are tagged.
untagged
Add a Layer 2 interface to a VLAN as an untagged interface.
Syntax
untagged interface
To remove an untagged interface from a VLAN, use the no untagged interface command.
Parameters
interface Enter the following keywords and the interface information:
• For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port
[/subport] information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
Defaults All interfaces in Layer 2 mode are untagged.
Command Modes INTERFACE VLAN
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
972 Layer 2