Service Manual

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for forty gigabit, vlan, and tengigabit ethernet interfaces. Introduced on
the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000 and added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol
route) is preferred over the Management Static route. Also, Management static routes and the Management
Connected prex are not reected in the hardware routing tables. Separate routing tables are maintained for IPv4
and IPv6 management routes. This command manages both tables.
Related Commands
• interface ManagementEthernet — congure the Management port on the system (either the Primary or
Standby RPM).
• speed (Management interface) — set the speed for the Management interface.
show arp
Display the ARP table.
Syntax
show arp [vrf vrf-name] [interface interface | ip ip-address [mask] |
macaddress mac-address [mac-address mask]] [retries] [static | dynamic]
[inspection {database | statistics][summary]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF.
NOTE: Use this attribute to start a BGP instance for either a specic address
family corresponding to the default VRF or an IPv4 address family
corresponding to a non-default VRF.
interface interface (OPTIONAL) Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
IPv4 Routing 805