Service Manual

Version Description
9.0.2.0 Introduced on the S6000.
9.0.0.0 Added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
management route
Congure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ip-address mask | ipv6-address 1.1.1.1prefix-length}
{forwarding-router-address | managementethernet | fortyGigE | vlan |
tengigabitethernet}
To remove a static route, use the no management route command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prex format) of the destination
subnet.
ipv6-address prex-
length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prex format) of the destination
subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the prex length in
the /x format.
The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
forwarding-router-
address
Enter an IP address (dotted decimal format) or an IPv6 address (x:x:x:x::x format) of a
forwarding router.
managementethern
et
Enter the keyword managementethernet for the Management interface on the
Primary RPM.
fortyGigE Enter the keyword fortyGigE to specify a forty Gigbit Ethernet interface.
vlan Enter the keyword vlan to specify a vlan interface.
tengigabitethernet Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernete interface.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
804 IPv4 Routing