Service Manual

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.3.1.0 Added the count option.
Example
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40
Usage Information
To stop packets from ooding the user terminal when debugging is turned on, use the count option.
debug ip packet
View a log of IP packets sent and received.
Syntax
debug ip packet [access-group name] [count value] [interface]
To disable debugging, use the no debug ip packet [access-group name] [count value]
[interface] command.
Parameters
access-group name Enter the keyword access-group then the access list name (maximum 16 characters)
to limit the debug output based on the dened rules in the ACL.
count value (OPTIONAL) Enter the keyword count then the count value. The range is from 1 to
65534. The default is Infinity.
interface (OPTIONAL) Enter the following keywords and the interface information:
•
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
•
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
780 IPv4 Routing