Service Manual

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.0 Introduced on the E-Series.
Usage Information This command is found on the Management interface only.
Related Commands
• interface ManagementEthernet — congure the Management port on the system (either the Primary or
Standby RPM).
• duplex (10/100 Interfaces) — congure duplex mode on physical interfaces with the speed set to 10/100.
• management route — congure a static route that points to the Management interface or a forwarding router.
stack-unit portmode
Split a single 40G port into four 10G ports.
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identier of the stack member to reset.
number Enter the port number of the port to be split.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S4048-ON.
9.7(0.0) Added support for dynamically fanning-out of interfaces on S6000. Introduced on the
S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
732 Interfaces