Service Manual

interface vlan
Congure a VLAN. You can congure up to 4094 VLANs.
Syntax
interface vlan vlan-id [of-instance{of-id}]
Parameters
vlan-id Enter a number as the VLAN Identier. The range is from 1 to 4094.
of-instance{of-id} Enter the keyword of-instance then the OpenFlow instance ID to add the VLAN to the
specied OpenFlow instance. The range is from 1 to 8.
NOTE: Associate the OpenFlow instance with the VLAN when the VLAN is
created. An existing VLAN cannot be associated with an OpenFlow instance.
Defaults Not congured, except for the Default VLAN, which is congured as VLAN 1.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1.(0.0) Introduced on the S4810; added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Usage Information
For more information about VLANs and the commands to congure them, see Virtual LAN (VLAN) Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs and IP ACLs are supported. For more
information, see Access Control Lists (ACL).
The following features are not supported on VLANs associated with an OpenFlow instance:
• IPv4
• IPv6
• MTU
If OpenFlow VLANs are congured on the switch, spanning-tree protocols cannot be enabled simultaneously.
Example (Single
Range)
Dell(conf)# int vlan 3
Dell(conf-if-vl-3)#
Related Commands
• interface — congure a physical interface.
694 Interfaces