Service Manual

• For a port channel interface, enter the keywords port-channel then a number.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the Z9500 and S6000-ON.
9.2(0.2) Introduced on the S4810 and S4820T. Added the receive parameters packet-type and
interfaces and their options.
feature
p-snooping
Enable FCoE transit and FIP snooping on a switch.
Syntax
feature fip-snooping
To disable the FCoE transit feature, use the no feature fip-snooping command.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Usage Information
Before enabling FIP snooping, assign the fcoeacl space using the cam-acl command. If not assigned, the
following error message is displayed:
Dell(conf)#feature fip-snooping
% Error: Cannot enable fip snooping. CAM Region not allocated for Fcoe.
Dell(conf)#cam-acl l2acl 2 ipv4acl 0 ipv6acl 0 ipv4qos 2 l2qos 0 l2pt 0
ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2
Dell(conf)#feature fip-snooping
600 FIP Snooping