Service Manual
Buffer threshold parameters:
pfc priority 0 buffer-size 40
pfc priority 3 buffer-size 50
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.3(0.0) Introduced on the S6000 platform.
dcb pfc-total-buer-size
Congure the total buer size for PFC in kilobytes.
Syntax
dcb pfc-total—buffer—size KB
Parameters
KB Enter a number in the range of 0 to 7787.
Default The default is 6592KB.
Command Modes CONFIGURATION mode
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.6(0.0) Introduced on the S5000.
9.3(0.0) Introduced on the S6000, S4810, and S4820T.
Usage Information
Congure the maximum buer available for PFC trac. You can choose to increase or decrease the buer size
that is allocated in the system by default. However, if you modify the PFC buer size lower than the previously
congured size, the system determines whether this reduction in size is valid without disrupting the existing
conguration. In such a scenario, disable and re-enable DCB. For example, if you modify the total buer size as
4000 KB from the previous size of 5000 KB, an error message is displayed that this reduction cannot be performed
owing to existing system conguration because of queues that are being currently in process.
The lossless queue limit per port is validated based on the dcb pfc-queues command. PFC queue conguration
identies the maximum number of queues a port can support. Although the queue limit per port is a baseline when
dynamic buering is enabled, the limit per port for queues depends on the availability of the buer.
Example
Dell(conf)# dcb pfc-total-buffer-size 5000
Dell(conf)# dcb pfc-total-buffer-size 4000
%ERROR: Total pfc buffer size configured cannot accommodate existing buffer
requirement in the system.
512 Data Center Bridging (DCB)