Service Manual

--------------------------------------
FCOE TLV Tx Status is disabled
ISCSI TLV Tx Status is disabled
Local FCOE PriorityMap is 0x8
Local ISCSI PriorityMap is 0x10
Remote FCOE PriorityMap is 0x8
Remote ISCSI PriorityMap is 0x8
0 Input TLV pkts, 1 Output TLV pkts, 0 Error pkts,
0 Pause Tx pkts, 0 Pause Rx pkts
show interface pfc statistics
Displays counters for the PFC frames received and transmitted (by dot1p priority class) on an interface.
Syntax
show interface port-type pfc statistics
Parameters
port-type Enter the port type and the interface information.
NOTE: This command also enables you to view information corresponding to a range of ports. However,
for Open Networking (ON) platforms the notation for specifying port range in the command is dierent
from how you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range. For example, if you want
to display information corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] - slot/port/
[subport]. For example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1/1 - 1/1/4.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Enabled to display the command output even without enabling DCB.
9.9(0.0) Added support to display the interface congurations corresponding to a range of ports.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
You can use this command even without enabling DCB.
Example (Summary)
Dell#show int te 1/1 pfc statistics
Interface TenGigabitEthernet 1/1
480 Data Center Bridging (DCB)