Service Manual

destination Enter the IP address of the network or host to which the packets are sent.
udf-pkt-format
name
Enter the keywords udf-pkt-format then the UDF ACL prole name.
udf-qualier-value
name
Enter the keywords udf-qualifier-value then the UDF qualier value prole name.
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
Example
Dell(config-ext-nacl)#permit ip any any udf-pkt-format ipinip udf-qualifier-
value ipnip_val1
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related Commands
ip access-list standard — congures a standard ACL.
ip access-list extended — creates an extended ACL.
show cong
Display the current UDF TCAM prole conguration.
Syntax
show config
Command Modes CONFIGURATION-UDF TCAM
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Example
Dell(conf-udf-tcam)#show config
!
udf-tcam ipnip seq 1
key innerL3header udf-id 6 packetbase innerL3Header offset 0 length 2
match l2ethertype ipv4 ipprotocol 4 vlantag any
!
udf-qualifier-value ipnip_val1
Dell(conf-udf-tcam)#
Access Control Lists (ACL) 269