Service Manual

udf-qualier-value
name
Enter the keywords udf-qualifier-value then the UDF qualier value prole name.
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
Example
Dell(config-ext-nacl)#deny ip any any udf-pkt-format ipinip udf-qualifier-
value ipnip_val1
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related Commands
ip access-list standard — congures a standard ACL.
ip access-list extended — creates an extended ACL.
feature udf-acl
Enable udf-acl feature on a switch.
Syntax
feature udf-acl
To disable the udf-acl feature, use the no feature udf-acl command.
Defaults Disabled
Command Modes CONFIGURATION
Example
Dell(conf)#feature udf-acl
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
key
Congure UDF data context for parsing the dierent header location oset and required bytes.
Syntax
key description udf-id id packetbase PacketBase offset bytes length bytes
266 Access Control Lists (ACL)