Service Manual

show vrrp ipv6
View the active IPv6 VRRP groups. If no VRRP groups are active, the Dell Networking OS returns No Active VRRP group.
Syntax
show vrrp ipv6 [vrid] [interface] [brief] [vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the virtual router identier for the VRRP group to view only that
group. The range is from 1 to 255.
interface Enter the following keywords and the number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a port channel interface, enter the keywords port-channel, and then a
number.
• For a VLAN interface, enter the keyword vlan, and then a number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the VRRP
groups.
vrf vrf-name Enter the keyword vrf then the name of the VRF to view IPv6 VRRP groups
corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series.
Usage Information The following describes the show vrrp ipv6 command.
Line starting
with
Description
GigabitEthernet... Displays the interface, VRRP group ID, and network address. If the interface is not
sending VRRP packets, 0.0.0.0 appears as the network IP address.
VRF VRF instance to which the VRRP group interface belongs.
1714 Virtual Router Redundancy Protocol (VRRP)