Service Manual

Version Description
8.3.1.0 Introduced on the C-Series and S-Series.
Usage Information Enable DEI before using this command.
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible command in its
conguration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface command.
Parameters
interface Enter the following keywords and the interface information:
• For a Port Channel interface, enter the keywords port-channel, and then a
number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
Defaults Not congured.
Command Modes CONF-IF-VLAN
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the C-Series and S-Series.
Usage Information Enable the stackable VLAN (using the vlan-stack compatible command) on the VLAN prior to adding a
member to the VLAN.
Related Commands
• vlan-stack compatible — enables stackable VLAN on a VLAN.
VLAN Stacking 1633