Administrator Guide

Version Description
7.6.1.0 Introduced on the S-Series and revised the output to display Native VLAN.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage
Information
The following describes the show vlan command shown in the following example.
Column
Heading
Description
(Column 1 — no
heading)
● asterisk symbol (*) = Default VLAN
● G = GVRP VLAN
● P = primary VLAN
● C = community VLAN
● I = isolated VLAN
● O = OpenFlow
NUM Displays existing VLAN IDs.
Status Displays the word Inactive for inactive VLANs and the word Active for active
VLANs.
Q
● Displays G for GVRP tagged
● M for member of a VLAN-Stack VLAN
● T for tagged interface
● U for untagged interface
● x (not capitalized x) for Dot1x untagged
● X (capitalized X) for Dot1x tagged
● o (not capitalized o) for OpenFlow untagged
● O (capitalized O) for OpenFlow tagged
● H for VSN tagged
● i (not capitalized i) for Internal untagged
● I (capitalized I) for Internal tagged
● v (not capitalized v) for VLT untagged
● V (capitalized V) for VLT tagged
Ports Displays the type, slot, and port information.
● Po = port channel
● Te = ten-gigabit Ethernet
● Fo = forty-gigabit Ethernet
Example
DellEMC# show vlan
Codes: * - Default VLAN, G - GVRP VLANs, P - Primary, C - Community, I -
Isolated
Q: U - Untagged, T - Tagged, O - Openflow
x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT
tagged
NUM Status Description Q Ports
* 1 Inactive
2 Active U Po1(Te 1/1)
T Po20(Te 1/6), Te 1/25
T Te 1/7
3 Active T Po20(Te 1/6)
T Te 1/7
U Te 1/1
4 Active U Po2(Te 1/2)
976 Layer 2