Administrator Guide

Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S4048–ON and S5048F-ON.
Usage
Information
This feature is applicable only for 10GBase-T optical ports.
NOTE: It is not supported for stacking ports.
enable stack-unit transceiver
Enable the 10GBase-T optical port that is reset due to high temperature to normal mode.
Syntax
enable stack-unit unit-number port port-number transceiver
Parameters
stack-unit unit-
number
Enter the keyword stack-unit then the unit-number for which you want to
enable temperature polling. The range is from 1 to 6.
port port-number Enter the keyword port then the port-number for which you want to enable
temperature polling. The range is from 1 to 48.
Defaults Enabled
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S4048–ON and S5048F-ON.
Usage
Information
This feature is applicable only for 10GBase-T optical ports.
NOTE: It is not supported for stacking ports.
encapsulation dot1q
Configures lite-subinterfaces.
Syntax
encapsulation dot1q vlan-id
To remove a previously configured lite-subinterface, use the no encapsulation dot1q vlan-id
command.
Parameters
dot1q vlan-id Enter the keyword dot1q followed by the VLAN ID to which the host belongs. The
range is from 1 to 4094. A lite subinterface is considered as a Layer 3 port property
and is synchronous with the existing rules of applying Layer 2 or Layer 3 properties
to an interface.
Command Modes
INTERFACE
Command
History
Version Description
9.12.1.0 Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
692 Interfaces