Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1751

Defaults Disabled

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.14(0.0) Introduced nsx and Nuage keywords on the S5048F–ON.

9.13(0.0) Introduced nsx and Nuage keywords on the S4048–ON, S4048T-ON, S6000,

S6000–ON, S6100–ON, S6010–ON, and Z9100–ON.

9.12(1.0) Introduced on the S5048F–ON.

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S6100–ON.

9.10(0.1P10) Introduced on the Z9100–ON.

9.8(0.0) Introduced on the S4048–ON.

9.7(0.0) Introduced on the S6000-ON.

9.4.(0.0) Introduced on the S6000.

Usage

Information

You must configure VXLAN globally before using VXLAN-instance. Use the no shutdown command to

enable the VXLAN instance.

Example

Enable VXLAN instance:

DellEMC(conf)#int 1/5/1

DellEMC(conf-if-te-1/5/1)#vxlan-instance 1

DellEMC(conf-if-te-1/5/1-vxlan-inst-1)#no shutdown

Disable VXLAN instance:

DellEMC(conf)#no vxlan-instance 1

Commands

feature vxlan — Enable VXLAN configuration globally on the platform.

vxlan-instance (VAP)

To configure a VXLAN-Access Port (VAP) in to VXLAN-instance

Syntax

vxlan-instance instance ID

To unconfigure VAP, use the no vxlan-instance 1 command.

Parameters

instance ID

Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the

initial release.