Administrator Guide

2. Configure a Layer 2 QoS policy with Layer 2 (Dot1p or source MAC-based) match criteria.
CONFIGURATION mode
DellEMC(conf)# policy-map-input l2p layer2
3. Apply the Layer 2 policy on a Layer 3 interface.
INTERFACE mode
DellEMC(conf-if-fo-1/49/1)# service-policy input l2p layer2
Applying DSCP and VLAN Match Criteria on a
Service Queue
You can configure Layer 3 class maps which contain both a Layer 3 Differentiated Services Code Point (DSCP) and IP VLAN IDs as match
criteria to filter incoming packets on a service queue on the switch.
To configure a Layer 3 class map to classify traffic according to both an IP VLAN ID and DSCP value, use the match ip vlan vlan-
id command in class-map input configuration mode. You can include the class map in a policy map, and apply the class and policy map to
a service queue using the service-queue command. In this way, the system applies the match criteria in a class map according to
queue priority (queue numbers closer to 0 have a lower priority).
To configure IP VLAN and DSCP match criteria in a Layer 3 class map, and apply the class and policy maps to a service queue:
1. Create a match-any or a match-all Layer 3 class map, depending on whether you want the packets to meet all or any of the match
criteria. By default, a Layer 3 class map is created if you do not enter the layer2 option with the class-map command. When you
create a class map, you enter the class-map configuration mode.
CONFIGURATION mode
Dell(conf)#class-map match-all pp_classmap
2. Configure a DSCP value as a match criterion.
CLASS-MAP mode
Dell(conf-class-map)#match ipdscp 5
3. Configure an IP VLAN ID as a match criterion.
CLASS-MAP mode
Dell(conf-class-map)#match ip vlan 5
4. Create a QoS input policy.
CONFIGURATION mode
Dell(conf)#qos-policy-input pp_qospolicy
5. Configure the DSCP value to be set on matched packets.
QOS-POLICY-IN mode
Dell(conf-qos-policy-in)#set ip-dscp 5
6. Create an input policy map.
CONFIGURATION mode
Dell(conf)#policy-map-input pp_policmap
7. Create a service queue to associate the class map and QoS policy map.
POLICY-MAP mode
Dell(conf-policy-map-in)#service-queue 0 class-map pp_classmap qos-policy pp_qospolicy
Classifying Incoming Packets Using ECN and
Color-Marking
Explicit Congestion Notification (ECN) is a capability that enhances WRED by marking the packets instead of causing WRED to drop them
when the threshold value is exceeded. If you configure ECN for WRED, devices employ this functionality of ECN to mark the packets and
reduce the rate of sending packets in a congested, heavily-loaded network.
ECN is a mechanism using which network switches indicate congestion to end hosts for initiating appropriate action. End hosts uses two
least significant bits of ToS to indicate that it is ECT. When intermediate network node encounters congestion, remarks ECT to CE for end
Quality of Service (QoS)
719