Users Guide

Configuring Management VRF
You can assign a management interface to a management VRF.
Table 88. Configuring Management VRF
Task Command Syntax Command Mode
Create a management VRF.
ip vrf management
CONFIGURATION
Assign a management port to a
management VRF.
interface management
VRF MODE
When Management VRF is configured, the following interface range or interface group commands are disabled:
• ipv6 nd dad — Duplicated Address Detection
• ipv6 nd dns-server — Configure DNS distribution option in RA packets originated by the router
• ipv6 nd hop-limit — Set hop limit advertised in RA and used in IPv6 data packets originated by the router
• ipv6 nd managed-config-flag — Hosts should use DHCP for address config
• ipv6 nd max-ra-interval — Set IPv6 Max Router Advertisement Interval
• ipv6 nd mtu — Configure MTU advertisements in RA packets
• ipv6 nd other-config-flag — Hosts should use DHCP for non-address config
• ipv6 nd prefix — Configure IPv6 Routing Prefix Advertisement
• ipv6 nd ra-guard — Configure IPv6 ra-guard
• ipv6 nd ra-lifetime — Set IPv6 Router Advertisement Lifetime
• ipv6 nd reachable-time — Set advertised reachability time
• ipv6 nd retrans-timer — Set NS retransmit interval used and advertised in RA
• ipv6 nd suppress-ra — Suppress IPv6 Router Advertisements
• ipv6 ad <ipv6-address> — IPv6 Address Detection
• ipv6 ad autoconfig — IPv6 stateless auto-configuration
• ipv6 address <ipv6-address> — Configure IPv6 address on an interface
NOTE:
The command line help still displays relevant details corresponding to each of these commands. However, these
interface range or interface group commands are not supported when Management VRF is configured.
Configuring a Static Route
To configure a static route, perform the following steps:
Table 89. Configuring a Static Route
Task Command Syntax Command Mode
Configure a static route that points to a
management interface.
management route ip-address
mask managementethernet
ormanagement route ipv6-address
prefix-length
managementethernet
NOTE: You can also have the
management route to point to a
front-end port in case of the
management VRF. For example:
management route 2::/64 te 0/0.
CONFIGURATION
To configure a static entry in the IPv6 neighbor discovery, perform the following steps:
Virtual Routing and Forwarding (VRF)
797