Users Guide

Examples: Entering the Hash Value for Verification

MD5

Dell# verify md5 flash://FTOS-SE-9.5.0.0.bin 275ceb73a4f3118e1d6bcf7d75753459

MD5 hash VERIFIED for FTOS-SE-9.5.0.0.bin

SHA256

Dell# verify sha256 flash://FTOS-SE-9.5.0.0.bin

e6328c06faf814e6899ceead219afbf9360e986d692988023b749e6b2093e933

SHA256 hash VERIFIED for FTOS-SE-9.5.0.0.bin

Using HTTP for File Transfers

Stating with Release 9.3(0.1), you can use HTTP to copy files or configuration details to a remote server. Use the copy source-file-url

http://host[:port]/file-path command to transfer files to an external server.

Enter the following source-file-url keywords and information:

• To copy a file from the internal FLASH, enter flash:// followed by the filename.

• To copy the running configuration, enter the keyword running-config.

• To copy the startup configuration, enter the keyword startup-config.

• To copy a file on the external FLASH, enter usbflash:// followed by the filename.

In the Dell Networking OS release 9.8(0.0), HTTP services are enhanced to support the VRF-aware functionality. If you want the HTTP

server to use a VRF table that is attached to an interface, configure that HTTP server to use a specific routing table. You can use the ip

http vrf command to inform the HTTP server to use a specific routing table. After you configure this setting, the VRF table is used to

look up the destination address.

NOTE: To enable HTTP to be VRF-aware, as a prerequisite you must first define the VRF.

You can specify either the management VRF or a nondefault VRF to configure the VRF awareness setting.

When you specify the management VRF, the copy operation that is used to transfer files to and from an HTTP server utilizes the VRF

table corresponding to the Management VRF to look up the destination. When you specify a nondefault VRF, the VRF table corresponding

to that nondefault VRF is used to look up the HTTP server.

However, these changes are backward-compatible and do not affect existing behavior; meaning, you can still use the ip http

source- interface command to communicate with a particular interface even if no VRF is configured on that interface

NOTE: If the HTTP service is not VRF-aware, then it uses the global routing table to perform the look-up.

To enable an HTTP client to look up the VRF table corresponding to either management VRF or any nondefault VRF, use the ip http

vrf command in CONFIGURATION mode.

• Configure an HTTP client with a VRF that is used to connect to the HTTP server.

CONFIGURATION MODE

Dell(conf)#ip http vrf {management | <vrf-name>}

Getting Started