Users Guide

Interfaces
This chapter describes interface types, both physical and logical, and how to configure them with Dell Networking Operating System (OS).
• The system supports 1 Gigabit Ethernet and 10 Gigabit Ethernet interfaces.
NOTE: Only Dell-qualified optics are supported on these interfaces. Non-Dell optics are set to error-disabled state by
default.
Basic Interface Configuration
• Interface Types
• View Basic Interface Information
• Enabling a Physical Interface
• Physical Interfaces
• Management Interfaces
• VLAN Interfaces
• Loopback Interfaces
• Null Interfaces
• Port Channel Interfaces
Advanced Interface Configuration
• Bulk Configuration
• Defining Interface Range Macros
• Monitoring and Maintaining Interfaces
• Splitting QSFP Ports to SFP+ Ports
• Link Dampening
• Link Bundle Monitoring
• Ethernet Pause Frames
• Configure the MTU Size on an Interface
• Port-pipes
• Auto-Negotiation on Ethernet Interfaces
• View Advanced Interface Information
Topics:
• Interface Types
• View Basic Interface Information
• Resetting an Interface to its Factory Default State
• Enabling a Physical Interface
• Physical Interfaces
• Egress Interface Selection (EIS)
• Management Interfaces
• VLAN Interfaces
• Loopback Interfaces
• Null Interfaces
• Port Channel Interfaces
• Bulk Configuration
• Defining Interface Range Macros
• Monitoring and Maintaining Interfaces
• Splitting QSFP Ports to SFP+ Ports
• Converting a QSFP or QSFP+ Port to an SFP or SFP+ Port
20
280 Interfaces